- 您现在的位置：买卖IC网 > Sheet目录985 > ISL29010IROZ-EVALZ (Intersil)EVALUATION BOARD FOR ISL29010
ISL29010
α = ------------
(EQ. 2)
Control Register 01(hex)
The Read/Write control register has one function:
1. Range/Gain; Bits 3 and 2. The Full Scale Range can be
adjusted by an external resistor R EXT and/or it can be
adjusted via I 2 C using the Gain/Range function.
Gain/Range has four possible values, Range(k) where k
is 1 through 4. Table 8 lists the possible values of
Range(k) and the resulting FSR for some typical value
R EXT resistors.
TABLE 8. RANGE/GAIN TYPICAL FSR LUX RANGES
FSR LUX FSR LUX FSR LUX
The proportionality constant α is determined by the Full
Scale Range (FSR), and the n-bit ADC, which is user
defined in the command register. The proportionality
constant can also be viewed as the resolution; the smallest
lux measurement the device can measure is α in Equation 2.
FSR
n
2
Full-Scale Range (FSR) is determined by the software
programmable Range/Gain, Range(k), in the command
register and an external scaling resistor R EXT , which is
referenced to 100k Ω .
FSR = Range ( k ) × ------------------
BITS RANGE@
3:2 k RANGE(k) R EXT = 100k
RANGE@
R EXT = 50k
RANGE@
R EXT = 500k
100k Ω
R EXT
(EQ. 3)
0:0
0:1
1:0
1
2
3
2,000
8,000
32,000
2,000
8,000
32,000
4,000
16,000
64,000
400
1,600
6,400
The transfer function effectively for each timing mode
becomes:
INTERNAL TIMING MODE
Range ( k ) × ------------------
R EXT
Range ( k ) × ------------------
R EXT
1:1 4 128,000 128,000 256,000 25,600
I 2 Sensor Data Register 04(hex) and 05(hex)
When the device is configured to output a signed 15-bit data,
the most significant byte is accessed at 04(hex), and the
least significant byte can be accessed at 05(hex). The
sensor data register is refreshed after every integration
cycle.
100k Ω
E = ---------------------------------------------------- × DATA
n
2
EXTERNAL TIMING MODE
100k Ω
E = ---------------------------------------------------- × DATA
COUNTER
(EQ. 4)
(EQ. 5)
Timer Data Register 06(hex) and 07(hex)
Note that the timer counter value is only available when
using the External Timing Mode. The 06(hex) and 07(hex)
are the LSB and MSB, respectively, of a 16-bit timer counter
value corresponding to the most recent sensor reading.
Each clock cycle increments the counter. At the end of each
integration period, the value of this counter is made available
over the I 2 C. This value can be used to eliminate noise
introduced by slight timing errors caused by imprecise
external timing. Microcontrollers, for example, often cannot
provide high-accuracy command-to-command timing, and
the timer counter value can be used to eliminate the
resulting noise.
TABLE 9. DATA REGISTERS
ADDRESS
n = 3, 7, 11, or 15. This is the number of clock cycles
programmed in the command register.
Range(k) is the user defined range in the Gain/Range bit
in the command register.
R EXT is an external scaling resistor hardwired to the R EXT
pin.
DATA is the output sensor reading in number of counts
available at the data register.
2 n represents the maximum number of counts possible in
Internal Timing Mode. For the External Timing Mode, the
maximum number of counts is stored in the data register
named COUNTER.
COUNTER is the number of increments accrued between
(hex)
04
05
06
07
CONTENTS
Least-significant byte of most recent sensor reading.
Most-significant byte of most recent sensor reading.
Least-significant byte of timer counter value
corresponding to most recent sensor reading.
Most-significant byte of timer counter value
corresponding to most recent sensor reading.
integration time for External Timing Mode.
Gain/Range, Range(k)
The Gain/Range can be programmed in the control register
to give Range(k) determining the FSR. Note that Range(k) is
not the FSR (see Equation 3). Range(k) provides four
constants depending on programmed k that will be scaled by
R EXT (see Table 8). Unlike R EXT , Range(k) dynamically
adjusts the FSR. This function is especially useful when light
Calculating Lux
The ISL29010’s output codes, DATA, are directly
proportional to lux.
E = α × DATA
6
(EQ. 1)
conditions are varying drastically while maintaining excellent
resolution.
FN6414.1
November 11, 2011
发布紧急采购，3分钟左右您将得到回复。
相关PDF资料
ISL29011IROZ-EVALZ
EVAL BOARD FOR ISL29011
ISL29012IROZ-EVALZ
EVALUATION BOARD ISL29012IROZ
ISL29013IROZ-EVALZ
EVALUATION BOARD FOR ISL29013
ISL29015IROZ-EVALZ
EVALUATION BOARD FOR ISL29015
ISL29018IROZ-EVALZ
EVALUATION BOARD FOR ISL29018
ISL29020IROZ-EVALZ
EVALUATION BOARD FOR ISL29020
ISL29021IROZ-EVALZ
EVAL BOARD FOR ISL29021IROZ
ISL29023IROZ-EVALZ
EVALUATION BOARD ISL29023IROZ
相关代理商/技术参数
ISL29010IROZ-T7
功能描述:光学数位转换器 ISL29010IROZ LIGHT TO-DIGTL OUTPUT SENS RoHS:否 制造商:ams 数据总线宽度: 峰值波长:470 nm 最大工作频率: 工作电源电压: 工作电流: 最大工作温度:+ 85 C 最小工作温度:- 40 C 封装 / 箱体:Chipscale-6 封装:Reel
ISL29011IROZ-EVALZ
功能描述:EVAL BOARD FOR ISL29011 RoHS:是 类别:编程器，开发系统 >> 评估板 - 传感器 系列:* 产品培训模块:Lead (SnPb) Finish for COTS
Obsolescence Mitigation Program 标准包装:1 系列:-
ISL29011IROZ-T7
功能描述:IC PROXIMITY SENSOR AMB LT 8ODFN RoHS:是 类别:传感器，转换器 >> 多功能 系列:- 其它有关文件:Automotive Product Guide 标准包装:2,500 系列:- 传感器类型:光线和近程 输出类型:I²C?
ISL29011IROZ-T7R5484
制造商:Intersil Corporation 功能描述:ISL29011IROZ-T7 DOMINANT ASSY AND UNISEM TEST ONLY - Tape and Reel 制造商:Intersil Corporation 功能描述:IC PROXIMITY SENSOR AMB LT 8ODFN 制造商:Intersil Corporation 功能描述:ISL29011IROZ-T7 DOMINANT ASSY AND CARSEM TEST ONLY T/R
ISL29012IROZ-EVALZ
功能描述:EVALUATION BOARD ISL29012IROZ RoHS:是 类别:编程器，开发系统 >> 评估板 - 传感器 系列:- 产品培训模块:Lead (SnPb) Finish for COTS
Obsolescence Mitigation Program 标准包装:1 系列:-
ISL29012IROZ-T7
功能描述:IC SENSOR LIGHT-DGTL I2C 6-ODFN RoHS:是 类别:传感器，转换器 >> 光学 - 光电探测器 - 环境光传感器 系列:- 产品培训模块:Lead (SnPb) Finish for COTS
Obsolescence Mitigation Program 产品变化通告:Product Discontinuation 25/Jun/2012 标准包装:2,500 系列:- 带接近传感器:无 波长:- 电源电压:1.7 V ~ 2 V 电流 - 暗（标准）:- 电流 - 光（典型值）:- 输出类型:数字 - I²C 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:6-UDFN 裸露焊盘 包装:带卷 (TR)
ISL29013IROZ
制造商:Intersil Corporation 功能描述:Light-To-Digital Sens,ISL29013IROZ
ISL29013IROZ-EVALZ
功能描述:EVALUATION BOARD FOR ISL29013 RoHS:是 类别:编程器，开发系统 >> 评估板 - 传感器 系列:- 产品培训模块:Lead (SnPb) Finish for COTS
Obsolescence Mitigation Program 标准包装:1 系列:-